Sample Changer:
Xsample 370

Automated FTIR wine analysis with Lyza 5000 Wine
Wide sample variety of wine, must, and must in fermentation
Automated setting of water reference for accurate results
Automated cell care procedures to improve instrument lifetime

Xsample 370 Contact

Key features
Technical specifications
Documents
Compatible instruments
Similar products
Consumables

Together with Lyza 5000 Wine, the Xsample 370 sample changer offers fully automated workflows for FTIR wine analysis. Filling, referencing, cleaning, and drying are conveniently performed without interaction. The flexible needle means the sample can be sucked out of a beaker placed onto the instrument or directly out of a bottle standing next to it.

Key features

Sample changer for easy and convenient operation

Save operator time: Perform measurements automatically in just a few steps. Results are delivered independently, irrespective of operator, and with zero variation in quality– every time. Say goodbye to costly remeasurements due to human error.

Sample changer for top-notch measurement results

Ensure top-quality measurements with automated water references. The Xsample 370 sample changer can even perform these references between measurements with zero interaction. This means time-consuming manual steps are avoided and accurate measurements guaranteed.

Leaving no room for error, the automated workflows cover a wide range of sample types, including wine, must, and must in fermentation.

Sample changer with automated cell care procedures

Especially if your instrument is not in use for a while, cell care is important but often forgotten. With automated cell care procedures, even when in idle mode, Xsample 370 helps improve the lifetime of your instrument. If you forget to clean the system or have other important work to do, the Xsample 370 sample changer performs all necessary steps – fully automated.

Technical specifications

Viscosity range	up to 1,000 mPa·s at ambient and measuring temperature
Filling mode	with peristaltic pump
Typical time for filling and measuring cycle	2min
Minimum sample volume	24mL (at 30% pump speed)
Environmental conditions (EN 61010)	indoor use only
Operating temperature	+15 °C to +35 °C (+59 °F to +95 °F)
Altitude	max. 3,000 m (9,840 ft)
Power supply	CAN interface
Dimensions excl. master instrument (L x W x H) Xsample 370	310 mm x 145 mm x 230 mm 12.2 in x 5.7 in x 9.1 in
Weight incl. packaging, excl. master instrument Xsample 370	approx. 7,6 kg (16,7551 lbs)
Weight excl. master instrument Xsample 370	4 kg (8.82 lbs)