Trust is good, traceability is better

Anton Paar GmbH in Graz is operating a calibration laboratory according to EN ISO/IEC 17025. Density and temperature calibrations of newly bought and already existing density meters as well as temperature calibrations of Anton Paar thermometers can be calibrated upon request.

We built it for you – we calibrate it for you!

Since December 2014, Anton Paar GmbH is accredited according to ISO 17025. This means that it is officially recognized that Anton Paar GmbH is technically competent to perform accurate and precise density and temperature measurements.

Anton Paar GmbH offers

  • density and temperature calibrations of Anton Paar’s portable and benchtop density meters, and
  • temperature calibrations of Anton Paar’s resistance thermometers.

A density calibration consists of the measurement of a certified reference standard, followed by the comparison of the obtained measurement result with the reference value of the standard. Anton Paar’s temperature laboratory provides comparison calibrations of resistance thermometers from 0 °C up to 200 °C with a measurement uncertainty of 0.01 °C (10 mK). The thermometers are calibrated in standard calibration baths using Standard Platinum Resistance Thermometers traceable to the International Temperature Scale 1990 (ITS-90).

If these measurements are performed according to a certified procedure and by an accredited laboratory, we speak about an ISO 17025 calibration.

Get the document

To receive this document please enter your email below.