Recommended Results

D - Time- and frequency-dependent measurements on printing inks

Relevant for yield point, flow properties and thixotropy, multiwave measurements

Introduction

Comparison of three printing inks regarding yield point, flow properties and thixotropy. The task is to define a suitable measuring procedure which takes a maximum of 20 minutes.

Experimental Setup

All measurements were carried out using an MCR rheometer with air bearing. The measuring system used was a parallel-plate geometry with a plate diameter of 25 mm (PP25). The measuring gap was 0.5 mm. A trim position of 0.6 mm was used.

Get the document

To receive this document please enter your email below.

Loading...

Error